FRANKFORD BULLET PULLER PILE DRIVER

FRANKFORD BULLET PULLER PILE DRIVER
FRANKFORD BULLET PULLER PILE DRIVER
FRANKFORD BULLET PULLER PILE DRIVER
Item #:BF1116083
Price:$59.95$47.96 SALE!
You save 20%!
Shipping: One flat fee of $12.95 per online order.
Exclusions apply. Click for details.
Availability:In Stock
MPN:1116083
Read 5 Reviews

Product Information

Pile Driver™ Bullet Puller

  • Compatible with cartridges up to .30-06
  • Mounts vertically to bench or wall
  • Low effort lever design uses spring power to pull bullets
  • Capture bullets and powder in integrated trap or in external container using tube with optional barbed fitting

Read 5 Reviews - Average Rating: 3.2 stars

Frankford Arsenal Pile Driver Bullet Puller

By S Peter P. on Aug 09, 2023
Great design. Pulls bullets that no other device would - .45 auto round nose, Berry plated 185 grain hollow base. Tight fit, loaded rounds show slight bulge where bullets are. Hammer type bullet pullers break on concrete for many rounds. These round nose bullets don't have enough straight surface for collet type bullet pullers, like no grip. If the device has an impact velocity of about 300 fps. a 224, 55 grain bullet would generate 22/7000 * 300 = 2.4 ft pounds of directed momentum, not much. Pulling. crimped 22 bullets might be difficult. A 185-grain bullet, 185/7000 *300 =,7.9 ft pounds of directed momentum, more than 3 times. Enough to make bullets fall out upon first time 3 out of 4.,
Device is noisy, wear hearing protection.
The shell holder assembly clamp is subject to being launched into your face when the tiny screw & bolt holding the clamp gets loose- wear eye protection Upon searching 30 minutes I finally found the small 3/8 wide hex nut. I cleaned up the tiny screw & nut with carb cleaner, blasted it clean with compressed air & reassembled with a drop of blue thread locker. Mounting is critical, I screwed the device into a 2X6 using all 8 screws, 2X6 attached to bench leg with 4 2 1/2-inch deck screws.
If I had to start over, I would apply thread locker to the shell holder assembly clamp screw/nut before using device.
WEAR EYE PROTECTION!

Never worked

By Kenneth W. on Jul 22, 2021
Getting a bullet out in a single try almost never happens. If you just keep trying usually, but not always, it will eventually get the job done. I have a lot of Frankfort Arsenal stuff. This is their only product that I have ever seen that is just a piece of junk.

Works very nicely

By Douglas L. on Aug 04, 2020
And faster than other methods. MUST be bolted to a table or bench, or the frame will likely break. Need to be careful you don't release the mechanism accidentally with your fingers not clear. Used on (100) 300BLK, (20) 300 Ham'r, might take two tries when a fairly heavy crimp is used. I attached a short length of tubing instead of the included bullet/powder trap, it sped up the process a lot

So far so good

By Nick R. on Jul 28, 2020
It is a great timesaver!! Ran through about 150 rounds of 40s&w in about 30 minutes.

Broke right away

By Greg G. on Jul 26, 2020
On the 15th 9mm bullet pull the item broke beyond repair. Can not recommend the product. Love the idea.
Was this page helpful? Submit your own rating by logging in.